Epstein Secrets

r 7500 hours since new or overhaul (which this one has not) it would not require shot peened again until it reaches that threshold. Best Regards, Thomas Grunwald Pratt & Whitney Global Operations Center Phone: Email: Please do not address e-mail direct) to Thomas Grunwald but rather send them to the Pratt &

the buyer and his quality control person are going to make their decision on whether to proceed by tomorrow, Even though Pratt has determined that Shop Peen is not necessary since the C-11 disc was not installed, I don't have a good feeling on whether buyer will proceed with purchase. Should I present P

or 7500 hours since new or overhaul (which this one has not) it would not require shot peened again until it reaches that threshold. Best Regards, Thomas Grunwald Pratt & Whitney Global Operations Center Phone: 860-565-0140 Email: Please do not address e-mail direct) to Thomas Grunwald but rather send them to

arding C-11 HPC Disc overhaul procedures if you could please assist? A question has come up in regards to proper procedure for Disc overhaul, mainly Shop Peen requirement. EFTA00818324 In 2009 the C-11 HPC Disc part #773128 was overhauled properly and placed in storage preserve according to PW procedure

or 7500 hours since new or overhaul (which this one has not) it would not require shot peened again until it reaches that threshold. Best Regards, Thomas Grunwald Pratt & Whitney Global Operations Center Phone: 860-565-0140 Email: Please do not address e-mail direct) to Thomas Grunwald but rather send them to

arding C-11 HPC Disc overhaul procedures if you could please assist? A question has come up in regards to proper procedure for Disc overhaul, mainly Shop Peen requirement. In 2009 the C-11 HPC Disc part #773128 was overhauled properly and placed in storage preserve according to PW procedures including Sho

or 7500 hours since new or overhaul (which this one has not) it would not require shot peened again until it reaches that threshold. Best Regards, Thomas Grunwald Pratt & Whitney Global Operations Center Phone: 860-565-0140 Email: Please do not address e-mail direct) to Thomas Grunwald but rather send them to

arding C-11 HPC Disc overhaul procedures if you could please assist? A question has come up in regards to proper procedure for Disc overhaul, mainly Shop Peen requirement. In 2009 the C-11 HPC Disc part #773128 was overhauled properly and placed in storage preserve according to PW procedures including Sho