tor at Credenza • Two (2) 24" HD widescreen LCD monitors on the forward side of the aft cabin bulkhead • One (1) 24" HD widescreen LCD monitor on the L/H forward cabin bulkhead • One (1) 19" HD widescreen LCD monitor on the R/H forward cabin bulkhead • Four (4) 28" single seats with 9" compatible L

the main cabin area window li=e that exist randomly throughout. You were partially correct in your assessment - you ma= have heard noise coming from the L/H fwd seat outboard area, but it was n=t from the headliner - it was most likely from the window line area where =here was absolutely no insulation a

ove table and lower side=panel "bumpout" at the #3 seat locations $24,300 2 EFTA_R1_01560494 EFTA02456968 15. Fabricate new veneer T.V. c=ver on the L/H forward cabin bulkhead $3,600 16. iPhone charger at the R/H #= ledge like on GIV $3,400 17. Raise arms on co-pilot seat=to match pilot seat, make p

onitors =nd recover $21,360 14. Remove table and lower side=panel "bumpout" at the #3 seat locations $24,300 15. Fabricate new veneer T.V. c=ver on the L/H forward cabin bulkhead $3,600 16. iPhone charger at the R/H #1= ledge like on GIV $3,400 17. Raise arms on co-pilot seat=to match pilot seat, make

onitors and=recover $21,360 14. Remove table and lower side pa=el "bumpout" at the #3 seat locations $24,300 15. Fabricate new veneer T.V. cove= on the L/H forward cabin bulkhead $3,600 16. iPhone charger at the R/H #2 l=dge like on GIV $3,400 17. Raise arms on co-pilot seat to=match pilot seat, make p

ining veneer located in Savannah is not enough to accomplish these pa=els., Gulfstream wants to make sure the Pattern of the replaced veneer matc='s the L/H and R/H sides of fwd bulkhead panels. Note, Eric'= process for finishing differs from Gulfstream, as we seen in the Silver Bu=ch samples you first

02614355 Foot Stool Fabricate a second foot stool (covered in carpet to match the existing) so that they both fit into the existing "bag dock" on the L/H mid cabin Sidewall Table Pulls Hard edges are uncomfortable against fingers. Cover edge in leather / rubber / trim this piece for comfort Aft Lav

on items. Foot Stool Fabricate a second foot stool (covered in carpet to match the existing) so that they both fit into the existing "bag dock" on the L/H mid cabin Sidewall Table Pulls Hard edges are uncomfortable against fingers. Cover edge in leather / rubber / trim this piece for comfort Aft Lava

ining veneer located in Savannah is not enough to accomplish then= panels., Gulfstream wants to make sure the Pattern of the replaced veneer=match's the L/H and R/H sides of fwd bulkhead panels. Note, Eric=E2 s process for finishing differs from Gulfstream, as we seen in the=Silver Burch samples you fir

Foot Stool=o:p> Fabricate a second foot stool (covered=in carpet to match the existing) so that they both fit into the existing &=8220;bag dock" on the L/H mid cabin Sidewall Table Pulls=/u> Hard edges are uncomfortable against f=ngers. Cover edge in leather / rubber / trim this piece for comforta:p>

August , : PM To: jeffrey E. Cc: Jay Massar; Maurice Blibaum; Tom Norden Subject: RE: Sub woofer Done. We will remove the magazine rack on the L/H fwd cabin bulkhead and install the subwoofer in it's place. Best Regards, Eric ERIC H. ROTH C > I www.intljet.com <http://www.intljet.com/> <ht

ect: Re: Sub woofer do you like the ideea On Tue, Aug 28, 2018 at 3:31 PM, Eric Roth <a>=wrote: So would you like for us to mount the =ubwoofer to the L/H forward bulkhead? Best Regards, Eric ERIC H. ROTH<=> I www.intljet.com <http://www.intljet.com/> <=pan style="font-size:8.0ptfont-family:"Calibr

e the ideea EFTA_R1_01837783 EFTA02625653 > wrote: On Tue, Aug 28, 2018 at 3:31 PM, Eric Roth So would you like for us to mount the subwoofer to the L/H forward bulkhead? Best Regards, Eric ERIC H. ROTH I I C I www.intljet.com <http://www.intljet.com/> <http://twitter.comniVintljet> <http://www.

ject: Re: Sub woofer do you like the ideea On Tue, Aug 28, 2018 a= 3:31 PM, Eric Roth > wrote: So would you like for us to mount the =ubwoofer to the L/H forward bulkhead? Best Regards, Eric ERIC H. ROTH<=> I I C I www.intljet.com <http://www.intljet.com > <=pan sty e= ont-size:8.0pt; ont- ami y

Eric Roth Subject: Re: Sub woofer yes On Tue, Aug 28, 2018 at 3:31 PM, Eric Roth &= > wrote: So would you like for us to mount the =ubwoofer to the L/H forward bulkhead? Best Regards, Eric ERIC H. ROTH<=> www.intljet.com <http://www.intljet.com/> <=pan style="font-size:8.0pt;font-family:"Calibr

Eric Roth <S> Sent: Tuesday, August 28, 2018 7:32 PM To: Jeffrey E. Subject: RE: Sub woofer So would you like for us to mount the subwoofer to the L/H forward bulkhead? Best Regards, Eric ERIC H. ROTH I PRESIDENT From: jeffrey E. [mailto:[email protected] Sent: Tuesday, August 28, 2018 3:3

6:49 PM To: Jeffrey E. Subject: RE: Sub woofer It is urgent if it is going to end up in the divan arm rest. There is a magazine rack mounted on the L/H fwd cabin bulkhead. Best Regards, Eric ERIC H. ROTH I PRESIDENT www.intljet.com <http://www.intljet.com/> chttp://twitter.com/fWintljet> <http:/

part of this system design and it needs to go back for optimum performance. We only see two opportunities and they are both in the fwd arm rest of the L/H divan: 1. Fwd side (we would need to create a speaker grill to allow acoustic penetration) 2. Aft side (see attached engineering drawing) where i

=part of this system design and it needs to go back for optimum performance= We only see two opportunities and they=are both in the fwd arm rest of the L/H divan: 1. Q Fwd side (we would need to create=a speaker grill to allow acoustic penetration) 2. 4P Aft side (see attached engineerin= drawing) wh

on items. Foot Stool Fabricate a second foot stool (covered in carpet to match the existing) so that they both fit into the existing "bag dock" on the L/H mid cabin Sidewall Table Pulls Hard edges are uncomfortable against fingers. Cover edge in leather / rubber / trim this piece for comfort Aft Lava