Document Mentions (3 shared documents)

EFTA02630245

4 mentions1 same-page

Page ?Same page

st team for dual valve change 1=11 add this to the $14,601 and present to Rusty for rectification, since Westfield overlooked t=is issue Thank you Larry Sent from my iPhone=<?xml version=.0" encoding=TF-8"?> <IDOCTYPE plist PUBLIC "-//Apple//DTD PLIST 1.0//EN" "http://www.apple.com/DTDs/PropertyList

From: Larry Visoski Sent: Wednesday, September 6, 2017 3:11 PM To:

stand corrected, HAPP MPP additional fee is $4867 for the next 3 years of this contract„tota= impact since it pre-existing problem., total $14,601 Valves are confirmed at $49,500 each. Once I get the final invoice for Gulfstream fast team for dual valve change 1=11 add this to the $14,601 and present

EFTA02630527

4 mentions1 same-page

Page ?Same page

From: jeffrey E. <[email protected]> Sent: Wednesday, September 6, 2017 4:23 PM To: Larry Visoski; Richard Kahn Subject: Re: HAPP not sure what this means what is the total that rich=needs to send rusty aside =br> On Wed, Sep 6, 2017 at 5:10

chard Kahn Subject: Re: HAPP not sure what this means what is the total that rich=needs to send rusty aside =br> On Wed, Sep 6, 2017 at 5:10 PM, Larry Visosk= <mailtoa> > wrote: Jeffr=y I stand corrected, HAPP MPP additional fee is $4867 for the next 3 years of this contract„tot=l impact since

Wednesday, September 6, 2017 4:23 PM To: Larry Visoski; Richard Kahn Subject: Re: HAPP not sure what

stand corrected, HAPP MPP additional fee is $4867 for the next 3 years of this contract„tot=l impact since it pre-existing problem., total $14,601 Valves are confirmed at $49,500 each. Once I get the final invoice for Gulfstream fast team for dual valve change=l'll add this to the $14,601 and present

EFTA00629960

3 mentions1 same-page

Page ?Same page

ated by LP "Fan Air" valve,. See Petes description for system operation below, he recommends swapping duct temperature sensor again for the system. Larry, As to the air system problems- I suspect that all of the control and monitoring systems are working properly- You may wish to swap the Temp sensors

From: Lany Visoski clia> To: Je vacation <[email protected]> S

lower the voltage/pressure to allow the LP valve to open slightly. Full closing would be higher voltage, and pressures, such as seen on the right- Valves are full open, ie: full cold, with no input- 3 volts/psi, would equate to allowing the valve to be partially open, cooling the bleed air to 400 degre