Back to Network
4
Shared Docs
4
Same-Page
4 / 4
Mentions
Document Mentions (4 shared documents)
2 mentions1 same-page
Page ?Same page
From: jeffrey E. <[email protected]> Sent: Sunday, April 10, 2016 8:32 PM To: Pete Rawson Subject: Re: GIV update the right and left were both showing 3 , until 25 mi= in and then right side again went to 9 and stayed there,Q we turne
erstood„ question , does the voltage max out at 9? My training manuals s=ow that the system is up to 14 VDC, it goes through a resistor and is a 10=VDC Maximum to the torque motor. Remember that the box=in the Radio Rack is an add-on, it is not normally installed, and there ar= no requirements for calibra
2 mentions1 same-page
Page ?Same page
From: jeffrey E. <[email protected]> Sent: Monday, April 11, 2016 10:23 AM To: Pete Rawson Subject: Re: GIV update 3 was the full 25 min climb then as you surmise it s=ips up to 9 . neither showed zero on anti wing ice on, . they showed
erstood„ question , does the voltage max out at 9? My training manuals s=ow that the system is up to 14 VDC, it goes through a resistor and is a 10=VDC Maximum to the torque motor. Remember that the box=in the Radio Rack is an add-on, it is not normally installed, and there ar= no requirements for calibra
2 mentions1 same-page
Page ?Same page
From: jeffrey E. <[email protected]> Sent: Monday, April 11, 2016 10:46 AM To: Pete Rawson Subject: Re: GIV update anti ice shows a slow slide from 9-1.7 o= the right and 3 - 1.5 on the left On Sun, Apr 10, 2016 at 7:27 PM, Pete Raw=on
erstood„ question , does the voltage max out at 9? My training manuals s=ow that the system is up to 14 VDC, it goes through a resistor and is a 10=VDC Maximum to the torque motor. Remember that the box=in the Radio Rack is an add-on, it is not normally installed, and there ar= no requirements for calibra
Sponsored
2 mentions1 same-page
Page ?Same page
From: jeffrey E. <[email protected]> Sent: Monday, April 11, 2016 11:49 AM To: Pete Rawson Subject: Re: GIV update one othr thing it says that the 12 stage=air is boosted to over 30 psi , when the throttles are reduced to idle? super
erstood„ question , does the voltage max out at 9? My training manuals s=ow that the system is up to 14 VDC, it goes through a resistor and is a 10=VDC Maximum to the torque motor. Remember that the box=in the Radio Rack is an add-on, it is not normally installed, and there ar= no requirements for calibra
Sponsored
Mutual Connections (7)
Entities connected to both Pete Rawson and VDC Maximum
