6
Shared Docs
6
Same-Page
6 / 6
Mentions
From: "Jeffrey E." <[email protected]> To: Pete Rawson Subject: Re: GIV update Date: Sun, 10 Apr 2016 20:31:59 +0000 the right and left were both showing 3 , until 25 min in and then right side again w
ning manuals show that the system is up to 14 VDC, it goes through a resistor and is a 10 VDC Maximum to the torque motor. Remember that the box in the Radio Rack is an add-on, it is not normally installed, and there are no requirements for calibration- The 9 volts seems to be appropriate for the full close si
From: Pete Rawson <[email protected]> To: Jeffrey E. <jeevacationggmaiLeom>, Larry Visoski <En CC: Pete Rawson <[email protected]> Subject: Re: GIV
ning manuals show that the system is up to 14 VDC, it goes through a resistor and is a 10 VDC Maximum to the torque motor. Remember that the box in the Radio Rack is an add-on, it is not normally installed, and there are no requirements for calibration- The 9 volts seems to be appropriate for the full close si
From: jeffrey E. <[email protected]> Sent: Sunday, April 10, 2016 8:32 PM To: Pete Rawson Subject: Re: GIV update the right and left were both showing 3 , until 25 mi= in and then right side again went to 9 and stayed there,Q we turne
ning manuals s=ow that the system is up to 14 VDC, it goes through a resistor and is a 10=VDC Maximum to the torque motor. Remember that the box=in the Radio Rack is an add-on, it is not normally installed, and there ar= no requirements for calibration- The 9 volts seems to =e appropriate for the full close si
From: jeffrey E. <[email protected]> Sent: Monday, April 11, 2016 10:23 AM To: Pete Rawson Subject: Re: GIV update 3 was the full 25 min climb then as you surmise it s=ips up to 9 . neither showed zero on anti wing ice on, . they showed
ning manuals s=ow that the system is up to 14 VDC, it goes through a resistor and is a 10=VDC Maximum to the torque motor. Remember that the box=in the Radio Rack is an add-on, it is not normally installed, and there ar= no requirements for calibration- The 9 volts seems to =e appropriate for the full close si
From: jeffrey E. <[email protected]> Sent: Monday, April 11, 2016 10:46 AM To: Pete Rawson Subject: Re: GIV update anti ice shows a slow slide from 9-1.7 o= the right and 3 - 1.5 on the left On Sun, Apr 10, 2016 at 7:27 PM, Pete Raw=on
ning manuals s=ow that the system is up to 14 VDC, it goes through a resistor and is a 10=VDC Maximum to the torque motor. Remember that the box=in the Radio Rack is an add-on, it is not normally installed, and there ar= no requirements for calibration- The 9 volts seems to =e appropriate for the full close si
From: jeffrey E. <[email protected]> Sent: Monday, April 11, 2016 11:49 AM To: Pete Rawson Subject: Re: GIV update one othr thing it says that the 12 stage=air is boosted to over 30 psi , when the throttles are reduced to idle? super
ning manuals s=ow that the system is up to 14 VDC, it goes through a resistor and is a 10=VDC Maximum to the torque motor. Remember that the box=in the Radio Rack is an add-on, it is not normally installed, and there ar= no requirements for calibration- The 9 volts seems to =e appropriate for the full close si
Entities connected to both Pete Rawson and the Radio Rack
Larry Visoski
PERSON
Jeffrey Epstein
PERSONValve
ORGANIZATIONThe LP air
ORGANIZATIONAnticipator
LOCATIONVDC Maximum
ORGANIZATIONthe Controller (ie
ORGANIZATIONAnticipators
PERSONWing heat
PERSONthe Controller (ie the Computer
ORGANIZATION